Industrial Sliding Gate

The Industrial Sliding Gate system is based on the principles of counter balancing. These systems are designed and engineered to exacting calculations and standards with a strong emphasis on safety.

Each Industrial Slide Gate system comprises the following important mechanical modules. The modules consist of the gate main support tower, the gate leaf, the gate back rail and the end post. When bolted together, the main tower and back rail form the main support and rolling platform for the gate leaf. The gate leaf is then attached to this platform with two back-check plate roller sets. The roller sets, when bolted on, lock the Sliding Gate leaf within the confines of the gate back rail.  

The gate system is then bolted to a concrete footing that has been engineered to provide adequate weight to counter-balance the gate system. The combination of gate design and concrete footing allows the gate to roll out over the relevant road opening, without tipping or sagging, basically travelling in free air.

Technical Data Heavy Industrial Sliding Gate

Gate Width

3 metres to 10 metres (custom available)

Gate Height

2200mm standard

Gate Clearance

150mm nominal

Gate Finish

Hot dip galvanised (optional 2 pack paint)


 0.75kw three phase brake motor

Gear Box

Worm drive (ratio’s variable)

Control Logic

 True PLC, 24v DC 

Drive Logic

 VSD 240v single phase to 240v three phase 

Power Supply

Regulated 240v to 24v DC

Safety (Pedestrian)

Photo electric cells, 24v DC, fail safe 

Safety (Vehicle)

Inductive loops & detectors, 24v DC, fail safe

Power Requirement

240v, 15 amp supply 


High impact safety screen – optional


Industrial Sliding gate PDF catalogue

Data Sheet

Industrial Sliding gate PDF catalogue

Enquire Now

Contact Supamaxx